Ran out of belt notches

(Boston_guy) #1

… won’t go small enough!

(Guardian of the bacon) #2

They sell leather punches.

(Larry Lustig) #3

Come to New York! We punch people for free!

(Stickin' with mammoth) #4

A sharp Phillips screwdriver and a hammer could fix that. Just make a starter nick with a utility knife and pound it over wood you don’t care about.

This thread is starting to sound dirty.

#5

Congats!

(Guardian of the bacon) #6

I’ll be traveling through on the way to Keto-fest, I’ll be sure to stop by. :laughing:

(A ham loving ham! - VA6KD) #7

It’s still dark in the morning when I get up for work and I get dressed in the semi-dark in order not to wake the other half. You know how you get used to pulling on the belt tongue in the dark to a certain tension and then the buckle is at the right spot for the notch? This morning I couldn’t for the life of me find the belt notch in the dark! I staggered into the light to find that I’d pulled the belt a good inch or two past the last notch. Yay! Time to dig out the hole punch.

Congrats on your NSV!

(Tom) #8

Congrats! I got one of these for Christmas, and it’s theoretically impossible to run out of notches with this belt (at least going down in size), since you can trim the belt from the buckle end. It worked nice enough I bought another one in a different color and different finish. Further, you can swap the belts and buckles if your fashion desires so dictate.
Vinicobelt on Amazon